What to do if you pour the laptop with water. Several ways, how to save the laptop from the spilled fluid: the advice of the experienced admin

The common cause of laptop breakdown is spilled drinks and water. The substance spilled on the device body immediately gets inside and envelops hardware components: the main motherboard, sound card, processor, cooling system and other elements. Users spill tea tea, beer, coffee, gas, water and other drinks on PC. According to statistics, each two-hundredth owner of a laptop computer sheds a cup of liquid on its device. Keep the cups away from PC, so you will never come across a mechanical breakdown, which is a consequence of spilled tea, coffee and so on. Consider several recommendations, how to fix the keyboard on the laptop and save the PC.

Liquid, laptop or PC needs repair

Types of liquids and their effect on the device

Ate liquid fell on the motherboard - this means that the contacts are closed, so the computer does not turn on. In this case, it is necessary to show a specialist. In the first minutes after the incident, you need to wash the keyboard of the laptop. Never use wet rags, wipe the keys only with dry antistatic tissues.

Keys crunch after spilled water? If the key on the laptop, thoroughly clean the key to the old toothbrush with the addition of an ordinary removal of nail polish. The tool removes pollution and instantly destroys alcohol and acetone in the composition.

To better understand how to do, read about the types of spilled fluid. The type of repair directly depends on the type of substance. Fluids are:

• dangerous (aggressive). Such substances are very quickly penetrated into the device and instantly cause serious harm to all hardware components of the system;
• safe (not aggressive). PC "is cured" from such funds in most cases.

Safety safe fluid

Follow the instructions below to reanimate the PC after filled with water:

if the user shed water to a laptop, turn off the laptop first. Hold the power button for five seconds, the device will turn off completely. Remove the battery. The sooner you de-energize the PC, the more repairs will be;

First of all - Disconnect the laptop battery

1. turn the laptop "upside down" to leak all the water. Leave a laptop computer in this position for a day. 24-48 hours are enough to ensure that the computer is completely pros;

   Never turn on a not dry computer and do not dry anything with a hairdryer!

2. quickly completing the first steps of the instruction, you will save time on further repair. After complete drying, the device will turn on. After switching on the buttons do not work? Replace the keyboard on the PC at home. Buy buttons for your PC model and install them, following the instructions for the PC model.

fully deraid and dry the PC. Read more Actions are described in the previous instruction;

in eighty percent of cases, the liquid falls on the buttons first, and then penetrates the case and fills the hardware components: the processor and the main fee. Manufacturers are added under the buttons a special film that prevents moisture penetration. If the user shed tea to a laptop, you first need to rinse the laptop keyboard after being filled, and then remove on the laptop. Clean the puffed surface with alcohol solution;

Flushing keyboard from aggressive liquid

1. if pc poured, first of all it is necessary to turn it over and deduce the keys. Humidity under the keyboard is a direct indicator that the hardware components are flooded and vice versa, the computer is not damaged from the inside if the pallet is dry keys. Remove the keyboard rinse with warm water with the addition of detergent.

After drying the PC does not turn on

If the PC does not turn on, take it into professional repair of laptops. During the incident, the motherboard was filled. It is very difficult to fix it on its own, and the replacement of the keyboard in the PC with their own hands is a completely possible action by the user.

To replace the buttons, disconnect them and rinse the keyboard. After all the excess components are washed away, it can not be thrown out. Buy only the original keyboard that corresponds to the device model.

View video

If you are working out in the PC structure, repair the internal components yourself: Open the case and remove the main fee. Carefully dry the fee and treat it with a dry tassel (cosmetic or artistic).

The greatest damage to the equipment can cause aggressive fluids. This includes sweet tea, coffee, juices, soda, etc. They can not only knock the contacts, but also lead to burnout schemes. Aggressive liquids will also lead to corrosion or to oxidation of conductors, which can not be able to make ordinary water or unsweetened tea.

First actions

As soon as the moisture got, it immediately needs to turn off the network and remove the battery. When the state is turned on, the degree of oxidation of boards and chips will be held at times faster, thereby increasing damage. Better to lose than all the equipment.

After that, turn it over it and put on the towel, thereby allowing the liquid to drain. This action can save the motherboard, which means it will only need to repair the keyboard.

What to do next

After the fluid from the laptop follows, take it to the service center immediately. Time here plays an important role. Regardless of whether the laptop is turned on or not, the oxidation in it is still occurring, the corrosion of each minute damages the increasing area of \u200b\u200bconductors. Ultimately, they will completely burn out. That is why it is necessary to dry the device as carefully.

It is important to note that the laptop's independent repair can lead to even greater breakdown, if there are no necessary skills. You can try to repair the keyboard if it suffered only, but the motherboard at home is to replace it difficult enough.

What else do you need to know

It is not necessary to hope that the fluid itself will evaporate without making significant harm. Even if the laptop continued his work after hung moisture, it will soon make their job - the equipment will have to be thrown away.

Especially this is relevant if you have shed an aggressive fluid. Maybe she follows, but will definitely leave the precipitate in the form of a syrup or a thin layer, the consequences of which will be corrosion of conductors and their burnout. In addition, the oxidation process can last both day and a few months. It all depends on the nature and amount of fluid.

What you need is that this does not happen

Observe the security technique. Do not put next to the laptop filled with liquid cups, mugs, glasses or open bottles. In no case do not take it in the bathroom, swimming pool, on the beach and in other places where moisture can get on it.

If such a nuisance happened to you and you poured a laptop with liquid, then in this situation in no case should be slow. Each lost minute can cost the lives of the device. In the first queue, you need to turn off the battery very quickly and pull out the battery.

The influence of a laptop or netbook is one of the most common reasons why they fail, and have to contact a computer service center. Manufacturers of equipment are trying in every way to protect their devices from fluid from entering the case. Covered with protective layers of paint and varnish Internal parts. But, unfortunately, it is not always possible to count on the fact that such measures will help save the laptop if you spend a cup of coffee, for example.

All fluids can be divided into two classes, depending on their danger: aggressive (there are alcoholic beverages, as well as sweet tea and coffee, other saham-containing drinks) and non-aggressive (clean water, tea and coffee without sugar).

Here is some algorithm of actions and measures to be done first if liquid got into the laptop:

• urgently disable power. In order not to spend the precious time and not to look for a socket in which the laptop is turned on, you can simply pull the plug from the device.
• get the battery. If the laptop flooded, then you should not worry about the safe shutdown of the operating system and save open documents and files.
• it is necessary to turn the laptop so that the fluid that falls into it can fall and do not penetrate even deeper into the case.
• if you shed a small amount of liquid and it is non-aggressive, then you can simply leave to succeed at least per day. However, you should not try to include it before this period. You can also try to suck with an ordinary hair dryer.

If the measures taken was not enough, and after the course of the day the laptop does not turn on or turn on, but, for example, the keyboard does not work, then you will have to contact the service center or try to eliminate the malfunction. However, without a complete parsing of the laptop you can not do.

Depending on which fluid flooded a laptop or a netbook, it is also necessary to act differently. Consider the easiest option when water was spilled by negligence. Be sure to determine how far and deep into the housing flowed fluid. Therefore, if after infinity and daily drying, the laptop did not work properly, you will have to disassemble it.

The keyboard of the laptop is filled. We repair yourself

First you need to remove the keyboard and carefully look at whether the liquid on the motherboard or the keyboard turned out to be filled. If it has a protective film pasted on the reverse side, then it can delay the penetration of the fluid inside the laptop housing for a while. Therefore, if you drain the liquid on time, then the losses can be minimal and you will need only replacing the keyboard, and at best it can be reanimated even it.

To do this, we need to rinse the keyboard under the jet of warm water, clean all the keys to the toothbrush. You need to dry about a day in a warm dry place, for example, on the battery. If you're lucky, then the poured laptop keyboard will completely return its performance, if not, you will have to buy a new one.

Poured a laptop motherboard or netbook

If you still are not lucky and liquid spilled on the laptop, was able to penetrate the motherboard, then you will have to disassemble completely. In the case when it was possible to quickly turn off and de-energize the equipment, there is a good chance to fully restore its work independently.

However, if after the laptop was flooded, he turned off himself, then, most likely, will not do without the help of computer service specialists and special equipment for diagnosis and repair. The best option will contact the service as soon as possible. Corrosion can quickly damage the motherboard so much that it will be impossible to restore it.

Despite the recommendation of specialists not to use different drinks during the computer, many modern users prefer to do as it is convenient. Often, everything ends with a spilled key to the surface of the keys with liquid and the panic search for the exit of the situation. If the keyboard from the computer or monoblock can be simply replaced, then it will not work with the keys on the surface of the laptop.

Some think that it is enough to pour the liquid, turning the device, and wait until it dies. In some cases, it really helps, but should not be surprised if after a few days or weeks after an accident will stop working.

Actions that need to be performed first

Emergency help consists of three stages, the correctness and speed of which will directly affect the status of the laptop. You need to start at the same time when the liquid, regardless of its quality and texture, was spilled:

1. Determining the device and pull out the battery. The correct completion of the system in order to preserve the data is not as important as the warning of a short circuit and combustion of all contacts. Contrary to popular belief, the battery shutdown is equally important, because in it, even after disconnecting from the network, the power schemes work.
2. After that, disconnect from the device flash drives, discs, memory cards.
3. Next, we act depending on the number of spilled water or other liquid. If its volume is no more than 1-2 tablespoons, then we turn the keyboard or laptop to prevent the moisture penetration into the central parts of the case, after which the surface with a paper towel is wedged. In the case of a larger volume, we install the device on the edge, the ventilation holes need to be located at the bottom, and gently shake, removing the maximum amount of fluid.

Tip: In the process of exercising emergency care, it is strictly forbidden to include the instrument to check whether it works. We will have to come to terms with the fact that the minimum of 2-3 days to use it does not have to.

Only by spending all these manipulations, you need to decide what to do next - try to clean and restore the device yourself or seek help in the repair shop.

Features of the effects of various liquids on the keyboard state

The degree of damage to the laptop depends not only on the volume, but also on the quality of the liquid spilled on its surface. All beverages are destroyed by all drinks, which must be taken into account during the repair process.

• Water. If the water was spilled on the keyboard, the chances of restoring the system are quite high, the product is quite harmless. The main thing is to act quickly and strictly according to the plan developed by experts, otherwise the risk of corrosion of individual elements arises. You must not forget that the clean product will spread through the internal movement of the device rapidly, increasing the possibility of short circuit. In no case can you just try to dry the keys, the processing should be full and consistent.
• Traditional drinks such as tea or coffee, including those in which sugar or milk are added. With such defeat, the situation is much worse due to acids that are part of most components. For example, tea contains a tannin with an acidic reaction. If milk is added to the drink, the level of negative impact is still rising. Coffee is also quite aggressive, and in combination with sugar and cream, it guarantees the appearance of a sticky layer interfering with the operation of the keys.
• Natural or packaged juice. Often consists of quite large particles that are able to hurt between the elements. In addition, the sweet drink contains fruit acids with a pronounced destructive effect.
• Beer. Not many know that beer not only leaves a sticky trail on plastic, but also corps the elements of the device due to the low content of acids. Many owners of laptops that were pouring beer, let and minimal volume, are faced with the fact that the product quickly fails, even if it did not give a failure.
• Suggage. Represents the highest possible danger. In Cola, sprite and their analogues an impressive amount of chemical components, oxidizing and corrosive internally of a laptop or keyboard. In this case, it will have to act very quickly, in just a few hours a drink can cause the device with irreparable harm.

Regardless of what was spilled on the surface of keys, coffee, wine, tea, juice, beer, or milk, it is necessary not just to get rid of excess fluid, but rinse the item with clean water. After that, you can go to the service center or proceed to independent repairs.

How can you restore a spoiled laptop yourself?

To qualitatively and correctly, do not necessarily contact the specialists. In general, they will be done with the device all the same, but at the same time a precious time may be missed, which, in the case of a spilled gas, is calculated for hours.

• First, the product needs to be disassembled. To do this, we are armed with suitable screwdrivers and, laying under the panel, the oilbox, we separately unscrew each cog. To not be confused with latches and hidden panels, it is recommended to use the instructions for the analysis of a particular model that can be found on the Internet. After that, we carry out inspection and evaluate damage. Before you do anything further, you need to disconnect the battery feeding the motherboard, preventing theoretically possible closure.

• Cleaning and flushing components. Armed with a magnifying glass, inspect all the elements of the keyboard or laptop, looking for signs of darkening of the material or the appearance of spots. All suspicious formations are removed with a soft cloth without a pile or a dry toothbrush. First you need to use the alcohol solution, then distilled water (in the extreme case we replace the component of drinking or filtered water). In the same way, you need to clean all the details of the device.
• If the board is damaged too much, then we take it out, processed in the traditional way and leave the minimum one per day.
• After processing, it remains to dry the laptop. Some wizards to accelerate the process of getting rid of unnecessary fluid advise to use a hairdryer, but this is too dangerous approach. If at least a little reap the device, you can melt various elements or drive dust where it is not necessary. It is better to leave the product for 1-2 days in a dry room without dust and with good ventilation. You need to take care so that the details do not hit the straight sun rays.

In the event of a laptop of water, all the same manipulations are carried out, you do not only need to rinse the product. After all the deadlines go through, you need to collect the device, it is better to do it according to the scheme, and not by memory. If the device does not turn on or does not work, you still have to contact the service center. Sometimes after such a cleaning, only the keyboard does not work, then you can try to replace it or attract an external device.